Removing wiper motor
Removing wiper motor
Author
Discussion

Pied Piper

Original Poster:

1,388 posts

276 months

Thursday 18th November 2010
quotequote all
Has anyone done it?

Is it easy/hard/fking impossible?

Mars

10,107 posts

243 months

Thursday 18th November 2010
quotequote all
Getting to it is a bit tough but I tried to leave the expansion tank in place while I did it. It'd be considerably easier removing the tank first.

skidoo

400 posts

219 months

Thursday 18th November 2010
quotequote all
remove the header tank and the mounting braket remove the wiper arms undo the big nut on the motor unplug the wires and 2 ten mm nuts on the motor mounting braket and pull it out should,nt take more than an hour

ncs

3,974 posts

311 months

Thursday 18th November 2010
quotequote all
May I suggest Rainex....or shall I bring 'the hammer'

nerd

Pied Piper

Original Poster:

1,388 posts

276 months

Thursday 18th November 2010
quotequote all
ncs said:
May I suggest Rainex....or shall I bring 'the hammer'

nerd
Hammer yes and a good set of goggles.

.Mark

11,104 posts

305 months

Thursday 18th November 2010
quotequote all
Slight aside, is the park switch on the motor in the same way as on the Chimaeras?

My wipers have a habit of stopping where the hell they like, changing the park switch on the other car fixed that.

Pied Piper

Original Poster:

1,388 posts

276 months

Thursday 18th November 2010
quotequote all
.Mark said:
Slight aside, is the park switch on the motor in the same way as on the Chimaeras?

My wipers have a habit of stopping where the hell they like, changing the park switch on the other car fixed that.
I am sure they are the same motors, as looking around the parts sites they say it does for both.

schimg

1,923 posts

282 months

Friday 19th November 2010
quotequote all
Pied Piper said:
.Mark said:
Slight aside, is the park switch on the motor in the same way as on the Chimaeras?

My wipers have a habit of stopping where the hell they like, changing the park switch on the other car fixed that.
I am sure they are the same motors, as looking around the parts sites they say it does for both.
They are the same...I have a spare one off a cerbera and one off a chimaera....neither of which have been tested...will probably put them into to Adrian Venn to get them refurbed and replace both the one on my cerbera and chimaera...amongst other winter jobs...

shoggyraminator

255 posts

205 months

Friday 19th November 2010
quotequote all
Some photos, if they load?







You need to remove the three black bungs on the housing to get at the three small bolts on the bulkhead. You do not need to fully remove them to get the housing removed as the housing holes are slotted.

.Mark

11,104 posts

305 months

Friday 19th November 2010
quotequote all
Cheers chaps, nice little job for me there.

Back on topic biggrin