Clutch relining
Discussion
http://www.autoandindustrial.globalhire.co.uk/html...
Auto and industrial did mine. Very happy with the result which is working fine. Be sure to check all the plates and the flywheel first though. Mine needed a skim so I added the amount of removed material onto the thickness of the plates to ensure the clutch pack kept the same thickness.
Auto and industrial did mine. Very happy with the result which is working fine. Be sure to check all the plates and the flywheel first though. Mine needed a skim so I added the amount of removed material onto the thickness of the plates to ensure the clutch pack kept the same thickness.
Andy, the key thing is getting them to reline to the correct thickness. IIRC I asked them to reline mine to a finished thickness of 8mm which should be safe.
The other contact I used was http://www.techcraft.co.uk/ they are based very close to the AP factory and were able to get individual clutch parts which the TVR specialists couldn't get hold of.
The other contact I used was http://www.techcraft.co.uk/ they are based very close to the AP factory and were able to get individual clutch parts which the TVR specialists couldn't get hold of.
Gassing Station | Cerbera | Top of Page | What's New | My Stuff