**Help - Coolant Temp Sensor or Thermostat**
**Help - Coolant Temp Sensor or Thermostat**
Author
Discussion

kmm

Original Poster:

1,781 posts

211 months

Sunday 5th December 2010
quotequote all
Hi, i've had a low temp reading on my temp gauge. It would normally sit on 90c, but won't go above a smudge over 75c. It's a S4 b5 1998. I thought it might be the coolant temp sensor after reading some threads on various forums, but i've changed that and still no difference. Next one to look at was the themostat, which is a pig to change apparently.

Just blocked off the radiator with some cardboard and on tick over for 15 mins reached up to just over 75c. The engine was already fairly warm from earlier. Tried to squeeze the top hose flat using a clamp and no change in temp. Stuck the heater on full blast and no drop in temp. It's -0.5 in my garage, so not too cold. Am i correct in saying that the thermostat open around 75c? If i let the engine go completly cold and start up. If the top coolant hose get warm before the gauge reads 70c would that point at thermostat? I could just have made an ar#e of clamping pipe or blocking off radiator.

Any thought on this one? Could the cts i bought from the dealer be faulty or the wrong one? Part # on new sensor 059 919 501 - green square 4 pin. Old one is part # 078 919 501 B - blue square 4 pin. I'll also try and find out from the dealer tomorrow, if i have the wrong sensor.
Thanks.

Tame Technician

2,467 posts

235 months

Sunday 5th December 2010
quotequote all
Sounds like a stat to me.

If the heater gets warm, I'd just let it run at 75, it wont do any damage running cool, once the winter is over is will be back to normal. Save changing the stat for when the cam belt is due as it needs to come off to do the job.

kmm

Original Poster:

1,781 posts

211 months

Sunday 5th December 2010
quotequote all
Yep, heater still get nice and warm. I have heard of someone sqeezing the thermostat out while leaving the camelt in place. I believe they had to slide the belt partialy off the pulley wheel?? Next cambelt not due until 2014 - i'll decide in the summer.
Thanks for the advice.