DIGI DASH 2...question

[colin 82]

Hello

the red warning light that indicates if the hand brake wont go off even when the hand brake is released.

Can in turn the light off? anyone know what the cause is??

please help

colin

[Dave Dax builder]

That light also doubles as the low brake fluid warning light(The second being its primary use). It either comes on when the handbrake is on or when the brake fluid is low.
I'd have a check of that.

Edited by Dave Dax builder on Sunday 2nd January 16:08

[colin 82]

Dave Dax builder said:

That light also doubles as the low brake fluid warning light(The second being its primary use). It either comes on when the handbrake is on or when the brake fluid is low.
I'd have a check of that.

Edited by Dave Dax builder on Sunday 2nd January 16:08

Superb. Thanks for the info dax builder.
I Didnt get a manual for it. I will go hav a look at the fluid levels

[colin 82]

Hello

The brake fluid does not seem to be low, but i will top it up in the morning.
I have also checked the wires.

Could it be anything else??

[Colin 1985]

A bad connection?

---

ETB Downloads

[Steve_D]

The more normal configuration is power to the lamp with the circuit completed to earth via either the low fluid switch or the handbrake switch.

Therefore for the light to be on....
One of the switches is defective. Try disconnecting them.
The wiring has shorted somewhere.
The handbrake switch has fallen off or is badly adjusted.

Steve

[colin 82]

thanks guys

[Texpis]

If the brake pads have wear sensors in, that will put that light on as well.

Mick

Edited by Texpis on Friday 7th January 18:56