Discussion
The problems have happened enough that I think they're pretty well understood so I don't think you'll have a hard time getting it fixed at the right garage.
There will probably be a fault code for whatever went wrong. If it's not tripped the CEL, and it happened under load, it might not be anything too bad - relatively speaking.
Know anyone with a code reader or anyone on the forums with Vagcom/Vcds live near you that you could bribe with some beer to read the codes? Where are you based?
There will probably be a fault code for whatever went wrong. If it's not tripped the CEL, and it happened under load, it might not be anything too bad - relatively speaking.
Know anyone with a code reader or anyone on the forums with Vagcom/Vcds live near you that you could bribe with some beer to read the codes? Where are you based?
OctyVrs said:
The problems have happened enough that I think they're pretty well understood so I don't think you'll have a hard time getting it fixed at the right garage.
There will probably be a fault code for whatever went wrong. If it's not tripped the CEL, and it happened under load, it might not be anything too bad - relatively speaking.
Know anyone with a code reader or anyone on the forums with Vagcom/Vcds live near you that you could bribe with some beer to read the codes? Where are you based?
I am in Huddersfield, I have used IVS Volkswagen Specialist found him very good, and I know he wouldn't charge for a diagnoses .There will probably be a fault code for whatever went wrong. If it's not tripped the CEL, and it happened under load, it might not be anything too bad - relatively speaking.
Know anyone with a code reader or anyone on the forums with Vagcom/Vcds live near you that you could bribe with some beer to read the codes? Where are you based?
Its a bit tricky if its not throwing up any warning lights / codes.
It could be a whole host of things:
MAF
N75 valve (controls boost pressure)
Turbo vanes sticking (quite common on the PD diesels iirc)
Boost leak (as suggested, quite common for them to blow intercooler hoses off)
Turbo failure
It could be a whole host of things:
MAF
N75 valve (controls boost pressure)
Turbo vanes sticking (quite common on the PD diesels iirc)
Boost leak (as suggested, quite common for them to blow intercooler hoses off)
Turbo failure
Lordglenmorangie said:
How long before I need new turbo, driving up a steep hill today lost power in a big way. I think the turbo cut out, it's OK now after turning engine of and re starting. I suspect the turbo may be on it's way out (68K) miles. Any advice apart from going to the cash machine 
I'd say that the most likely problem is the variable turbo vanes which stick with carbon deposit build-up. It seems even more likely given it reset itself after turning off/on.
When the vanes stick in the low rev position and you accelerate, the thrust sensor (VAG MAF sensor) registers an overboost and you're into limp mode. My Seat (130PD) has done it on the M6 at 75mph going up a hill.
Apparently, you can put in some sort of chemical cleaner onto the turbo vanes (can't remember the name), or strip the turbo down to clean. You also need to make sure the actuator lever can move throughout its range and lubricate with silicon, not WD40.
My Seat has done this a couple of times and still runs ok. I occasionally drive all the way to work in third to get some revs and heat into the turbo. No idea if this makes any difference, but I was told it could help burn off stick carbon deposits.
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff


