'97 Golf VR6 braking shakes
'97 Golf VR6 braking shakes
Author
Discussion

cliff123

Original Poster:

458 posts

273 months

Thursday 6th January 2011
quotequote all
Hi. I still have a good but now aging Golf vr6 Highline '97, having bought new. It's my run around, but is used daily. The car has a 140k miles on the clock, but the engine is still pulling very sweetly and everything else is pretty good.

However 7 months ago it started to get mild shaking while under solid braking, which became more prominent over time with lighter braking. I have just replaced the front hubs and had a four wheel alignment at vw. It does now turn in again beautiful, and tracks perfectly, but... it still shudders a little under anything but town driving. I had this problem a year ago and replaced both the front disks and pads and the problem went away for a week, and then returned. Admittedly I fitted none VW parts,from the local motor factor. Could these less then great parts have failed in a weeks driving? Could the disks and pads be the issue again? Does anyone have any other suggestions before I spend more money on these parts to find it's something else? If I buy new disks and pads are vw supplied one the ones to get, or do you suggest a particular brand?

Thank you, any advice to resolve this issue would be much appreciated.

Matt_N

9,047 posts

233 months

Friday 7th January 2011
quotequote all
Might be worth getting the bushes checked out, in particular wishbone bushes?

If you do want to change the pads and discs again, try GSF or Eurocarparts, they sell Zimmerman and Brembo discs, never had a problem with them on my Mk2 GTI.

Roop

6,018 posts

315 months

Friday 7th January 2011
quotequote all
Back when I had my Mk.3 Golf GTI, I was having a friendly blat with a bloke in a VR6. Braking solidly into a roundabout, the OSR wheel was literally bouncing because the shock was knackered. I got him to wind the window down and told him.

I guess with the wheel alignment and all it's unlikely they didn't notice a knackered shock, but thought I'd mention it anyway.

Could try cleaning the discs by doing subsequent stops getting faster and braking harder each time. This is supposed to help clean up glazed pads and dirty discs (the latter is often mistaken for warping).

Dr G

16,017 posts

273 months

Friday 7th January 2011
quotequote all
Back to basics and I apologise if this is anything you've already tried!

Jack the car up or get it on a ramp and hold a front wheel and 12 and 6, try to rock it back and forth across it's centre. Play here can indicate a duffed balljoint.

Do the same at 9 and 3, this will show wear in a rod end, bearing, wishbone bush... look at all the rubbers very closely, the round wishbone bushes on these are stone age technology and don't last all that long. As Matt_N pointed out they're a likely culprit and a new, complete lower wishbone is inexpensive if you wanted to eliminate this.

It's unlikely (but possible) discs have died again although it sounds to me like something is allowing the hub to move when braking loads transfer through it.