AUDI S6 C5 THERMOSTAT CHANGE
AUDI S6 C5 THERMOSTAT CHANGE
Author
Discussion

jubblyray

Original Poster:

17 posts

191 months

Saturday 22nd January 2011
quotequote all
Hi,

Please can someone advise me if is possible to change the thermostat without removing the cambelt i.e still taking the front end off and drainig the cooling system.

thanks in advance

jith

2,752 posts

246 months

Saturday 22nd January 2011
quotequote all
jubblyray said:
Hi,

Please can someone advise me if is possible to change the thermostat without removing the cambelt i.e still taking the front end off and drainig the cooling system.

thanks in advance
You don't have to take off the front end completely. You remove the bumper and the fixings for the front panel and fit extension bolts to the front member to allow the whole assembly to slide forward. This then gives you plenty of access to remove the serpentine belt and cam covers. You then have to slacken the timing belt tensioner and ease the belt about halfway off the right hand, (driver's side) cam pulley. Be very careful not to pull it right off or you will have to completely reset the cam timing.

You do have to partially drain the cooling system, and then remove the thermostat housing by taking off the two fixings securing it and swivelling it past the belt.

Best of luck.

James.

jubblyray

Original Poster:

17 posts

191 months

Sunday 23rd January 2011
quotequote all
Thanks for the explanation , I wonder if an independant audi specialist would consider using this method/approach to change my thermostat.

jith

2,752 posts

246 months

Sunday 23rd January 2011
quotequote all
jubblyray said:
Thanks for the explanation , I wonder if an independant audi specialist would consider using this method/approach to change my thermostat.
I am an independant Audi specialist. This is the official factory method of changing the thermostat, from the workshop manual, and 40 years experience!

I would do the job for you, but I'm in Glasgow!

Regards,

James

jubblyray

Original Poster:

17 posts

191 months

Sunday 23rd January 2011
quotequote all
Thank you for your response again, Please can you tell me how many hours labour would be an acceptable charge for such a job thanks in advance.

jith

2,752 posts

246 months

Tuesday 25th January 2011
quotequote all
jubblyray said:
Thank you for your response again, Please can you tell me how many hours labour would be an acceptable charge for such a job thanks in advance.
Sorry for the late reply, awfy busy!

The problem with this job is usually seized fixings on the bumper and inner wheel arch guards, so it has to be charged by the hour. It can be anything from 3 to 6 hours dependant on that.

Regards,

J

jubblyray

Original Poster:

17 posts

191 months

Thursday 27th January 2011
quotequote all
Well can someone please restore my sanity,
I have been to an independent Audi specialist and he thinks changing my thermostat is not required , My reasons for thinking the thermostat is defective are that the car reaches normal running temperature within 2 and a half miles of driving the oil temp gauge takes longer to reach normal running temperature , then the car will run all the time either for a 5 minute trip or a five hour trip remaining rock steady at normal running temperature BUT the bottom pipe on my radiator is cold/Luke warm is this normal ?



jubblyray

Original Poster:

17 posts

191 months

Friday 28th January 2011
quotequote all
anybody ?

jith

2,752 posts

246 months

Friday 28th January 2011
quotequote all
jubblyray said:
Well can someone please restore my sanity,
I have been to an independent Audi specialist and he thinks changing my thermostat is not required , My reasons for thinking the thermostat is defective are that the car reaches normal running temperature within 2 and a half miles of driving the oil temp gauge takes longer to reach normal running temperature , then the car will run all the time either for a 5 minute trip or a five hour trip remaining rock steady at normal running temperature BUT the bottom pipe on my radiator is cold/Luke warm is this normal ?
I changed my thermostat last month and it transformed the car. The engine management system is totally dependant on engine temperature being spot on. That way you will get the best performance and fuel efficiency. The way your car warms up sounds about right, but I would be very concerned about the cold water hose.

Does it stay cold if you let the car idle for a while? If so it looks like your radiator is partially blocked. The only way to determine if it is, is to remove it and have a flow test done.

On my A6, the hose outlet would burn you when fully warmed up, and this is the same for most vehicles.

jubblyray

Original Poster:

17 posts

191 months

Friday 28th January 2011
quotequote all
Hi,
I will try leaving the engine ticking over for a while Tommorow after a run a see what happens, I have been back to the Audi specialist and he was not concerned about my symptoms.

If i were to dissconnect the bottom hose of the radiator and run the engine for a few seconds would i be able to assess/check the flow rate through the radiator?

jubblyray

Original Poster:

17 posts

191 months

Sunday 30th January 2011
quotequote all
Well I have taken the car for a run tonight then parked on the drive and let the car run on tick over for 15 minutes
The temperature gauge never flickered from 90 degrees position the oil gauge hardly moved from its normal warm position.
And the bottom radiator pipe was very hot, So do i assume my thermostat is ok?

jith

2,752 posts

246 months

Sunday 30th January 2011
quotequote all
jubblyray said:
Well I have taken the car for a run tonight then parked on the drive and let the car run on tick over for 15 minutes
The temperature gauge never flickered from 90 degrees position the oil gauge hardly moved from its normal warm position.
And the bottom radiator pipe was very hot, So do i assume my thermostat is ok?
I think you have to take a more relaxed approach with this, if you don't mind me saying so.

It sounds as if your thermostat is fine, but there can only be two problems with them. When the thermostat becomes faulty it jams either open or closed. If it jams closed you have instant overheating that can lead to serious engine damage. If it jams open the car will run too cold, which in the long term can also accelerate engine wear. It sounds as if yours is fine.

The oil temperature will only rise when the car is driven for a distance or a reasonable amount of time. If you drive it hard you will notice a significant rise in temperature, but this is completely normal as oil runs at a much higher temperature than water in the cooling system.

Relax and enjoy your car.

J

jubblyray

Original Poster:

17 posts

191 months

Monday 31st January 2011
quotequote all
Hi,
Thankyou for your response again, Have just bought my own petrol tanker smile

jith

2,752 posts

246 months

Monday 31st January 2011
quotequote all
jubblyray said:
Hi,
Thankyou for your response again, Have just bought my own petrol tanker smile
Is the thermostat ok? wink

jubblyray

Original Poster:

17 posts

191 months

Monday 31st January 2011
quotequote all
Yes the thermostat is fine, Just me.

Now i have to deal with 3 fault codes!!!

16711 and 16716 knock sensors circut low input (check/clean connections/re torque/new sensors)?

17521 bank 1 sensor 1 internal resistance too high O2 pre sensor, which side ? scratchchin

cars eh smile