Discussion
Owned the car for about a year & a half now. Been pretty reliable couple of little niggles when I first got it which my brother luckily came to the rescue for me. But overall been a great car had it on the rollers when I first got it made 265@flywheel hopefully its nearer 280-300 region now with a few extra bits engine mods so far are-
Apexi air filter
Blitz Nur spec exhaust
Aussie de cat downpipe
SSQV BOV
Forge Actuator
Uprated fuel pump
ACT uprated clutch
short shift kit
EBC set between 1-1.1 bar of boost
Plans for the future are to get a couple of bodywork bits tidied up & possibly a piggyback ecu.
RobCrezz said:
Very nice.
You should replace the charge cooler (sell to an MR2 turbo owner) and get a big FMIC in there
From my understanding unless your running high power (500bhp+) there is little point ditching the chargecooler. Its a very good setup, and in most cases replacing it will raise temps. You should replace the charge cooler (sell to an MR2 turbo owner) and get a big FMIC in there

Edited by GWMD on Monday 7th February 15:10
Clint westwood said:
Lovely car!
I have always wondered what is the little intake for on the bonnet?
On the WRC cars they found that the cambelt got rather hot and was likely to snap/have problems etc unless it was cooled, hence one "cannon port" cooling vent although that I know of its blocked off so does nothing on the road car but for homologation reasons it stayed on the car.I have always wondered what is the little intake for on the bonnet?
Gassing Station | Readers' Cars | Top of Page | What's New | My Stuff




