Tuscan/Vixen finned alloy wheel caps
Discussion
I got a set from http://stores.ebay.co.uk/Allaggro-Old-Car-Accessor... last year. They don't always list them but I'm sure if you email them they'll have some or make you some. If I remember correctly they were £9.99 for 4. They also had TVR England logo that was on my original set.
Nige
Nige
http://www.classiccapsule.com/tvr-wheel-badges-to-...
I think these are the same as in the previous post, and the design is the closest I've seen to the original badges.
Unfortunately they are not hard plastic caps but can be applied over old caps, don't know whether you could get away just sticking these on to the wheels.
PS The original wheel caps have a diameter of 68mm.
I think these are the same as in the previous post, and the design is the closest I've seen to the original badges.
Unfortunately they are not hard plastic caps but can be applied over old caps, don't know whether you could get away just sticking these on to the wheels.
PS The original wheel caps have a diameter of 68mm.
Andy,
I think that I sourced mine from classic capsule. They're great but as Mike says, they're not as hard plastic as the original items.
They are sticky backed and if you specify the correct diameter they will sit on the flat of the wheel over the centre hole. Having placed them in situ, I spayed contact adhesive in through the back of the wheel to provide a stronger bond and better seal. However, one badge reacted to the cold temperature of the aerosol and lost it's shape. The supplier was very good and sent me a replacement, but best not to use spray glue.
Steve
I think that I sourced mine from classic capsule. They're great but as Mike says, they're not as hard plastic as the original items.
They are sticky backed and if you specify the correct diameter they will sit on the flat of the wheel over the centre hole. Having placed them in situ, I spayed contact adhesive in through the back of the wheel to provide a stronger bond and better seal. However, one badge reacted to the cold temperature of the aerosol and lost it's shape. The supplier was very good and sent me a replacement, but best not to use spray glue.
Steve
If you don't like to glue the nice TVR badges directly on the alloys try a set of this
http://cgi.ebay.co.uk/MGB-MGBGT-Rostyle-Wheel-Cent...
They fit the finned alloys very well and they look great with the TVR- instead of the MG-Logo
http://cgi.ebay.co.uk/MGB-MGBGT-Rostyle-Wheel-Cent...
They fit the finned alloys very well and they look great with the TVR- instead of the MG-Logo
Gassing Station | TVR Classics | Top of Page | What's New | My Stuff