Blowing Fuses when selectin reverse
Blowing Fuses when selectin reverse
Author
Discussion

Deep Down

Original Poster:

27 posts

209 months

Wednesday 9th February 2011
quotequote all
Every time I select reverse, the fuse blows, so the brake lights don't work either. Disconnected the reversing light so that leaves the reversing switch or a break in the wiring. Does anyone have a wiring diagram. About to attempt to get to the reversing switch has anyone any tips.

Thanks in advance.

glow worm

7,405 posts

256 months

Wednesday 9th February 2011
quotequote all
I had the same problem. I had my garage sort out the bad connection between the pin on the gear stick and the plate . I'm afraid its a real TVR bodge job, apparantly the proper connection could not be used because of the heat caused by the proximity to the exhaust. You can get at it from underneath with the car on a ramp ,but its awkward, otherwise its take the centre console off.

Rich912

201 posts

245 months

Wednesday 9th February 2011
quotequote all
I also had this problem and it was the reverse light switch that is mounted on the gearbox next to the gear stick.

The plastic insulator between the ball bearing and switch internals had worn a tiny hole in it which shorted it out every time reverse was selected. Its an old ford part but they no longer stock them, you can buy them from the normal TVR suppliers. As has already has been said its a center console out job to fit it.

Its fairly simple job to fit although the lack of space doesn't help.

Rich

Deep Down

Original Poster:

27 posts

209 months

Thursday 10th February 2011
quotequote all
Sorted, it's the reversing switch, all disconnected, up and running, thankfully I don 't do much reversing in the dark.

glow worm

7,405 posts

256 months

Friday 11th February 2011
quotequote all
As a matter of interest.. Is that an MOT failure ??? No reversing light ?


Oh.. Just noticed you are in France.... Well what do the French know about TVRs smile .. Tell them it never had a light whistle




Edited by glow worm on Friday 11th February 18:17

Rich912

201 posts

245 months

Friday 11th February 2011
quotequote all
No its not an MOT failure, however its up to you to keep your vehicle in a roadworthy condition so the police can still stop you for it.

engelborghs

241 posts

297 months

Saturday 12th February 2011
quotequote all
I had that problem when driving in Wales.
Had to change the fuse every time I had to reverse !!!!
Came back(>800km) without having to reverse once.

Problem was located in the gear-box reverse contact which is a Ford part. Finally a 4 hours dealer-job.


Koen