Fuel pump problem
Discussion
Hi all,
I'm sure this has been covered here before but i'm having problems with the fuel pump. To give the full scenario-
Fuel pump not priming.
Immobiliser clicks when disarmed.
Dash whacked on LHS.
Engine cranks.
12v across fuel pump terminals.
ECU and pump relays checked and swapped.
Still nothing.
Is there a chance that it could be the fuel pump unit itself? I've had it off the car and wired it up using a 12v battery, it kind of kicked into life at first but then was very noisy and died. Then it would only work sporadically.
Any help would be great- it's quite a frustrating problem as it could be a number of things.
Thanks, James
I'm sure this has been covered here before but i'm having problems with the fuel pump. To give the full scenario-
Fuel pump not priming.
Immobiliser clicks when disarmed.
Dash whacked on LHS.
Engine cranks.
12v across fuel pump terminals.
ECU and pump relays checked and swapped.
Still nothing.
Is there a chance that it could be the fuel pump unit itself? I've had it off the car and wired it up using a 12v battery, it kind of kicked into life at first but then was very noisy and died. Then it would only work sporadically.
Any help would be great- it's quite a frustrating problem as it could be a number of things.
Thanks, James
gateeast said:
Evening,
I had this problem, it ended up being the metal square relays separate to the fuse board etc.
First I removed them and gave them a gentle tap and the car started fine after, I have since replaced them and no problems at all.
Hope this helps.
But 12v at the pump says, knackered pump.I had this problem, it ended up being the metal square relays separate to the fuse board etc.
First I removed them and gave them a gentle tap and the car started fine after, I have since replaced them and no problems at all.
Hope this helps.
spend said:
It also has an integral non reverse valve so I wouldn't think wiring it the wrong way wouldn't achieve very much?
The motor still spins backards quite happily and kicks the muck out,that hopefully you can drain out with any remaining fuel in the inlet, but no you dont get a reverse flow as such. I found this out the hard way when bits of rust from the fuel tank used to jam the pump up on a regular basis (No filter fitted by Ginetta at this point). A quick reverse of the connections used to get me homeward bound for a while until it would do it again, and again, and again. New pump an filter, fuel tank sealed internally with an anti rust compound, and a strong magnet on the tank bottom to hold any swarf/ rust flakes seem to have cured it.
3024E said:
SCHREIDER VALVE.... Hows that for anorakism????
I think they have a ball check valve in them.Gassing Station | Griffith | Top of Page | What's New | My Stuff



