Battery powered under-unit kitchen lighting
Battery powered under-unit kitchen lighting
Author
Discussion

Gad-Westy

Original Poster:

16,220 posts

237 months

Saturday 5th March 2011
quotequote all
Does such a thing exist? I realise that the correct way to do this is to wire into the mains but I'm not prepared to pay for the expense of redecorating etc.. If there is a cost effective battery powered solution for occasional use though I'd be very interested.

singlecoil

35,788 posts

270 months

Saturday 5th March 2011
quotequote all
What voltage and current draw does the lighting amount to? Would something like a small car battery do the job? If so, they hold plenty of power and assuming fairly light load might only need a recharge every week or so.

singlecoil

35,788 posts

270 months

Saturday 5th March 2011
quotequote all
I've been thinking about this some more, and think I might have misinterpreted your requirements. Are you looking for (for instance) flourescent lights to go under the wall units each with its own battery? Is there no socket on that wall that you could plug a daisy chained set of lights into? If there are such sockets, and they are fully utilised alreay, there are conversion sockets available that will convert and exisiting twin socket into a triple.

Blakeatron

2,556 posts

197 months

Saturday 5th March 2011
quotequote all
We have rechargable strip fluorescents at work for working in dark places, the smallest one is about 2' long and maybe 2" wide.

Some velcro on the back and voila you are away!

Sorry not sure on the make though!

Simpo Two

91,486 posts

289 months

Saturday 5th March 2011
quotequote all
Many places sell battery powered LED lights about 3" diameter - you just stick them on.

Gad-Westy

Original Poster:

16,220 posts

237 months

Saturday 5th March 2011
quotequote all
Cheers all. Will investigate further

Simpo Two

91,486 posts

289 months

Saturday 5th March 2011
quotequote all
Or you can pillage the electricity supply from your cooker hood and rout channels for it down the back of your cabinets, then a well aimed hole through the base...