Best place to put an Anderson connector (Keep it clean!)
Best place to put an Anderson connector (Keep it clean!)
Author
Discussion

BillC99

Original Poster:

348 posts

191 months

Monday 21st March 2011
quotequote all
I am going to fit an Anderson connector soon and wondered where the best place was to mount it?
As it is usually needed when the battery is flat I was thinking under the front of the car somewhere? Anyone done this?

Tyre Tread

10,696 posts

247 months

Monday 21st March 2011
quotequote all
In the front passenger footwell

dbv8

8,676 posts

251 months

Monday 21st March 2011
quotequote all
In front of the radiator.
Or at least accessable if the batteries dead

ralphy12345

330 posts

196 months

Monday 21st March 2011
quotequote all
dbv8 said:
In front of the radiator.
Or at least accessable if the batteries dead
That's where mine is going, although the battery is now in the boot I'll run the +ve from the starter motor and pick up an earth from the front of the chassis.

R



spend

12,581 posts

282 months

Monday 21st March 2011
quotequote all
Its still bloomin dirty in the undertray (as well as wet!) You'd need to 'bag' it & I can't really see anywhere easily accessible that doesn't interfere with airflow to the rad OTTOMH?

Theres a nice flattish lip on the return from the underside of the undertray you might be able to easily reach?

Personally I'd stick the connector by the battery & just have low amp connector in the nose to enable the opening of doors (and trickle charging...) wink


MPoxon

5,329 posts

204 months

Monday 21st March 2011
quotequote all
I have the Leven kit fitted to mine which inlcudes a plug to stop crap getting inside it.

You can see the connector attached to the chassis rail in bottom right of the pic:



I also have the anderson connector for my accumate charger which I prefer to the cigarette lighter connector.

SantaPod

54 posts

228 months

Tuesday 22nd March 2011
quotequote all
put mine in the passenger footwell......

scotty_d

6,795 posts

225 months

Tuesday 22nd March 2011
quotequote all
If its out side the car a cap above like that packed with silicon grease will keep moisture out

BillC99

Original Poster:

348 posts

191 months

Tuesday 22nd March 2011
quotequote all
Thanks for your suggestions. I think I,ll go for the under car at the front option. The kit I've ordered has a dust cap so if I cable tie a poly bag over the whole connector it should keep it dry.

Mr Nordic

346 posts

266 months

Wednesday 23rd March 2011
quotequote all
I connected mine to the battery and then cut a slit in the glove bag, routed the cable so that the Anderson sits inside the glove bag/box under the dash and the cable goes directly to the battery.

This is out of sit and stays nice and clean.