wiper motor

[timshap]

Just taken the motor out and fitted new brushes and a general clean up. I am putting the motor housing back on but the end cap in the middle has a small gasket and T shaped bearing to support the armature shaft.There is a ball bearing also at the end of the shaft.

The bits fell out of the end cap and I cant remember if the gasket goes in first then the T so that the ball bearing touches the small plate of the T.

I have also noticed that the thrust bearing at the other end needs to be slacked off otherwise its all too tight and wont turn.

just wondering if Adrian is still about?

did all this stuff years ago but stuck this time

Thanks