Rear Wishbone - am I missing something?

[roseytvr]

Having Por15 all four corners, polybushed etc I am currently assembling the two rear corners. I have come to fit the top rear wishbones and there is quite a big gap of 5-6 mm at the front fitting to the carrier. Am I missing something here? I cant remember spacers on the back set up. Is this gap normal?
Thanks
Ian

[Adrian@]

Try this link....http://www.pistonheads.com/gassing/topic.asp?h=0&f=9&t=958010&mid=3530&nmt=Rear+upper+arm+nip...+Fitting+Powerflex.+have+I+lost+a+bit%3F
Adrian@

Edited by Adrian@ on Saturday 23 April 15:15

[TVR Beaver]

I still have the bending jig if you wish to use it!!... (read the above post )

[roseytvr]

Thanks guys - very helpfull.
I used two washers off the original bolts to pack is and it seems fine. Will be booking in for a geo soon and will get it all check then
Ian