Steering wheel
Discussion
Thanks for the replies Chaps, thought I would check the forum before resorting to ebay!
Adrian@, I thought there was a standard black leather one that I have seen on the majority of S's.
The wooden version of wheel seems to vary a bit.
If you have a leather one for sale, a photo would be greatly appreciated? Thanks
Adrian@, I thought there was a standard black leather one that I have seen on the majority of S's.
The wooden version of wheel seems to vary a bit.
If you have a leather one for sale, a photo would be greatly appreciated? Thanks
Ok ladies/gents, I now have (thanks to Adrian), a leather steering wheel (6 screw attachment). My next issue is: distance on new wheel hole to opposite hole is 75mm, but my wooden wheel is 100mm. Can someone please point me at a suitable hub for the replacement wheel? I'll transfer to my phone and see if I can post a photo.
Thanks
Thanks
I've taken my old wheel and hub off to see what I need to install the leather replacement.
Been looking on the web but not sure exactly what I need?
My current hub is as follows
So, the hub is in two halves. The outer hub is attached to the inner hub via 3 screws/ nyloc nuts. I can't see anything on the web that looks like a replacement for the outer hub (with 6 bolt x 74mm pcd).
Can anyone offer any guidance please?
Thanks
Been looking on the web but not sure exactly what I need?
My current hub is as follows
So, the hub is in two halves. The outer hub is attached to the inner hub via 3 screws/ nyloc nuts. I can't see anything on the web that looks like a replacement for the outer hub (with 6 bolt x 74mm pcd).
Can anyone offer any guidance please?
Thanks
Thanks for all the replies Chaps. I've looked at literally hundreds of hubs, bosses, adapters on the web this weekend until my eyes have gone sore, and seen a couple of options that might work, some with some minor fettling. Some of the advertised options look to be correct but surprisingly lack some of the key information or view of both sides which is annoying.
Shame I haven't got the tools to manufacture one myself, but in the end I will just have to pick one and if it doesn't fit, go through the inconvenience of sending it back.
Cheers all.
Shame I haven't got the tools to manufacture one myself, but in the end I will just have to pick one and if it doesn't fit, go through the inconvenience of sending it back.
Cheers all.
Gassing Station | S Series | Top of Page | What's New | My Stuff