Bracket brake regulator (take 2)
Discussion
phillpot said:
Han if you look close you may see I made a little "mod". drilled a 6mm hole between the spot welds, brazed a nut on and a bolt screwed in to tighten against the valve.
The idea was to stop it moving and scratching the paint (normally there is only a clip at the rear). Still managed to chip the paint so hence the grey tape around it to act as a kind of grommet.
Hello Mike,The idea was to stop it moving and scratching the paint (normally there is only a clip at the rear). Still managed to chip the paint so hence the grey tape around it to act as a kind of grommet.
Thanks for the tip , will have a look to improve the bracket.
Han
Gassing Station | S Series | Top of Page | What's New | My Stuff