Valve Clearances
Discussion
Just checking all the clearances now after a full rebuild( engine not run) and some are on the lower end for clearance and some mid point. None at the upper end.
Whilst its all out and I have new shims would you start at lower end( smallest gap) mid or largest.
When the engine runs in do they close or open in gap with wear.
Also just checking I measure between shim and the foot of the new folowwer yes? NOT between cam and top of follower?
Thank you
David
Whilst its all out and I have new shims would you start at lower end( smallest gap) mid or largest.
When the engine runs in do they close or open in gap with wear.
Also just checking I measure between shim and the foot of the new folowwer yes? NOT between cam and top of follower?
Thank you
David
Edited by anonymous-user on Sunday 20th November 10:48
Gassing Station | Speed Six Engine | Top of Page | What's New | My Stuff