Finger Follower - Design Revisions 2000-2005
Discussion
Photographed 14th December 2005 - Noted the visual design changes. comments on this would be appreciated. I am off to measure these up and produce the engineering model for them.
The casting on the old item is a far better quality than the new, you can see how porus the material is in the machined 14mm dia bore finish, the supprise came from the oilway feed to the cam lobe being inconsistent. The holes do manage to penetrate, but are certainly "underdrilled" on some.
On measuring up the item, the oil feed has been drilled at a shallower angle to the 2000 model. This certainly would change the direction of the oil spray to the cam lobe.
>> Edited by justinbaker on Wednesday 14th December 15:33
The casting on the old item is a far better quality than the new, you can see how porus the material is in the machined 14mm dia bore finish, the supprise came from the oilway feed to the cam lobe being inconsistent. The holes do manage to penetrate, but are certainly "underdrilled" on some.
On measuring up the item, the oil feed has been drilled at a shallower angle to the 2000 model. This certainly would change the direction of the oil spray to the cam lobe.
>> Edited by justinbaker on Wednesday 14th December 15:33
Gassing Station | Speed Six Engine | Top of Page | What's New | My Stuff