Moto-Concept BOV question

[Skerd]

Today the mailman delivered my Moto-Concept BOV. I only have one question..........how the heck does it install? If I could read German things would be a lot easier.

The parts in question are an aluminum square with a tapered connection sticking out on opposite sides. These tapered connections do not fit in the two plastic connections sticking out of the actual BOV device itself. So I have four seperate connections for two hoses?

There are also two brass circular shaped things. They are way to big to go around anything supplied with the kit?

I checked Andy Whittakers site, but the pictures shown are for a recirculating one, mine is non-recirculating. Andy Whittaker also mentions there are two ways to install it: Where the MAP sensor connects OR at the back of the fuel rail. Which is better?

The only thing I (think I) know is the small screwdriver supplied adjusts an adjustable screw on the
aluminum square for fine tuning.

Thanks for any help. It is for a 1995 S4s.

Mike

[Skerd]

Guy - Thanks, that is exactly what I needed. The only remaining question is that square aluminum thing which looks integral in the installation but not mentioned in those instructions?

Calvin - Thanks, I sent him an e-mail. You apparently also didn't use that square aluminum thing. I guess I will have some parts left over!

Mike