Drayton Wiser - Hints and Tips Thread
Discussion
Fastdruid said:
Fore Left said:
Today Only. Wiser TRVs for £24.27
https://www.hotukdeals.com/deals/drayton-wiser-sma...
Fill yer boots
Nice. I've ordered one. Only one as need to apply the discount to get down to £24.27 and only one per customer. https://www.hotukdeals.com/deals/drayton-wiser-sma...
Fill yer boots
Ive clicked through the link to amazon, but its still £34.27
Ive installed my wiser system today and have a couple of issues:
1. the override buttons on the hub (CH & HW) do not work
2. when the system is calling for heat, my boiler cycles on (1 min) and off (2 mins) constantly. It is set on the oil boiler, as that is what I have.
Any ideas how to resolve these?
1. the override buttons on the hub (CH & HW) do not work
2. when the system is calling for heat, my boiler cycles on (1 min) and off (2 mins) constantly. It is set on the oil boiler, as that is what I have.
Any ideas how to resolve these?
Audis5b9 said:
Ive installed my wiser system today and have a couple of issues:
1. the override buttons on the hub (CH & HW) do not work
2. when the system is calling for heat, my boiler cycles on (1 min) and off (2 mins) constantly. It is set on the oil boiler, as that is what I have.
Any ideas how to resolve these?
What controls did you have before?1. the override buttons on the hub (CH & HW) do not work
2. when the system is calling for heat, my boiler cycles on (1 min) and off (2 mins) constantly. It is set on the oil boiler, as that is what I have.
Any ideas how to resolve these?
B'stard Child said:
Audis5b9 said:
B'stard Child said:
What controls did you have before?
Just one wireless Drayton thermostat, which has been taken out of the system (I think!)What have you installed - Wiser and a room stat or have you added smart TRV’s on rads?
Just put the batteries back in the wireless thermostat and the override buttons now working. So clearly need to have another shot at removing that from the system.
Now testing the cycling issue, but suspect this is the issue causing the problem.
My FIL (Sparky) installed it, he wasn't entirely sure what he was doing with it, so will get him back to have another go at it. Any advice for identifying the wiring to remove / bypass from the system?
Audis5b9 said:
B'stard Child said:
Audis5b9 said:
B'stard Child said:
What controls did you have before?
Just one wireless Drayton thermostat, which has been taken out of the system (I think!)What have you installed - Wiser and a room stat or have you added smart TRV’s on rads?
Just put the batteries back in the wireless thermostat and the override buttons now working. So clearly need to have another shot at removing that from the system.
Now testing the cycling issue, but suspect this is the issue causing the problem.
My FIL (Sparky) installed it, he wasn't entirely sure what he was doing with it, so will get him back to have another go at it. Any advice for identifying the wiring to remove / bypass from the system?
Is the system S plan or Y plan (I’m assuming loft based CW store and gravity fed HW tank and CH header tank also in the loft?
Audis5b9 said:
Fastdruid said:
Fore Left said:
Today Only. Wiser TRVs for £24.27
https://www.hotukdeals.com/deals/drayton-wiser-sma...
Fill yer boots
Nice. I've ordered one. Only one as need to apply the discount to get down to £24.27 and only one per customer. https://www.hotukdeals.com/deals/drayton-wiser-sma...
Fill yer boots
Ive clicked through the link to amazon, but its still £34.27
B'stard Child said:
Where is the receiver for the wireless stat - I’d assume it was near the wiring centre?
Is the system S plan or Y plan (I’m assuming loft based CW store and gravity fed HW tank and CH header tank also in the loft?
Not sure what system we are on. whats the difference?Is the system S plan or Y plan (I’m assuming loft based CW store and gravity fed HW tank and CH header tank also in the loft?
"I’m assuming loft based CW store and gravity fed HW tank and CH header tank also in the loft?" - the hot water tank is on the landing, plus tanks in the loft
Audis5b9 said:
Ive installed my wiser system today and have a couple of issues:
1. the override buttons on the hub (CH & HW) do not work
2. when the system is calling for heat, my boiler cycles on (1 min) and off (2 mins) constantly. It is set on the oil boiler, as that is what I have.
Any ideas how to resolve these?
Review potential wiring issues from page 2 of this very thread.1. the override buttons on the hub (CH & HW) do not work
2. when the system is calling for heat, my boiler cycles on (1 min) and off (2 mins) constantly. It is set on the oil boiler, as that is what I have.
Any ideas how to resolve these?
Audis5b9 said:
B'stard Child said:
Where is the receiver for the wireless stat - I’d assume it was near the wiring centre?
Is the system S plan or Y plan (I’m assuming loft based CW store and gravity fed HW tank and CH header tank also in the loft?
Not sure what system we are on. whats the difference?Is the system S plan or Y plan (I’m assuming loft based CW store and gravity fed HW tank and CH header tank also in the loft?
"I’m assuming loft based CW store and gravity fed HW tank and CH header tank also in the loft?" - the hot water tank is on the landing, plus tanks in the loft
Y Plan - one 3 port valve that can do HW, HW and CH or CH only
Audis5b9 said:
Fastdruid said:
Fore Left said:
Today Only. Wiser TRVs for £24.27
https://www.hotukdeals.com/deals/drayton-wiser-sma...
Fill yer boots
Nice. I've ordered one. Only one as need to apply the discount to get down to £24.27 and only one per customer. https://www.hotukdeals.com/deals/drayton-wiser-sma...
Fill yer boots
Ive clicked through the link to amazon, but its still £34.27
Audis5b9 said:
B'stard Child said:
What controls did you have before?
Just one wireless Drayton thermostat, which has been taken out of the system (I think!)Very pleased with the system, simple to use and seems to be working ok for the past 24 hours.
Will keep an eye out for the smarts TRV's so I can put them on the remaining rads.
Audis5b9 said:
Audis5b9 said:
B'stard Child said:
What controls did you have before?
Just one wireless Drayton thermostat, which has been taken out of the system (I think!)Very pleased with the system, simple to use and seems to be working ok for the past 24 hours.
Will keep an eye out for the smarts TRV's so I can put them on the remaining rads.
If the first then more TRV's would help but if the latter you might want to think about if you really need more "Smart" TRV's
I've taken 1 Smart TRV out of the system - it still reports temp of the room but no longer controls the room temp and I'm probably going to take out a few more if I go over to 24/7 with setbacks
My room stat has decided to play silly buggers today.
The heating is set to come on at 18 degrees.
I'm thinking it feels cold in here,look at the app and it's showing 20.5 degrees.
So I get a regular thermometer and put it next to the Wiser room stat, it's showing 15.5 degrees .No wonder I feel cold .
Batteries are good, tried taking them out and refitting but makes no difference.
Is it kaput ?
The heating is set to come on at 18 degrees.
I'm thinking it feels cold in here,look at the app and it's showing 20.5 degrees.
So I get a regular thermometer and put it next to the Wiser room stat, it's showing 15.5 degrees .No wonder I feel cold .
Batteries are good, tried taking them out and refitting but makes no difference.
Is it kaput ?
It’s worth checking the battery strength.
If the batteries are OK try a reset and recalibrate
Reset without losing pairing
If the batteries are OK try a reset and recalibrate
Reset without losing pairing
- Twist the cap to the plus '+' position and hold there for up to 10 seconds, until you see all 3 LEDs flashing. Before you finish, make sure the radiator thermostat is recalibrated (below)
- To recalibrate the radiator thermostat, twist the cap to the minus '-' position and hold there for up to 5 seconds, until you see a continuous blue LED
AW10 said:
It’s worth checking the battery strength.
If the batteries are OK try a reset and recalibrate
Reset without losing pairing
It's the room stat not the trvIf the batteries are OK try a reset and recalibrate
Reset without losing pairing
- Twist the cap to the plus '+' position and hold there for up to 10 seconds, until you see all 3 LEDs flashing. Before you finish, make sure the radiator thermostat is recalibrated (below)
- To recalibrate the radiator thermostat, twist the cap to the minus '-' position and hold there for up to 5 seconds, until you see a continuous blue LED
Gassing Station | Homes, Gardens and DIY | Top of Page | What's New | My Stuff