LPG Tank above to below ground
Discussion
GT03ROB said:
FilH said:
Would a shed do?
Helped put a b&q shed up a few year back to hide a mates unsightly heating oil tank. Which looked a lot better, and they went on to add a few potted plants and baskets around the shed.
For LPG that is not allowed.Helped put a b&q shed up a few year back to hide a mates unsightly heating oil tank. Which looked a lot better, and they went on to add a few potted plants and baskets around the shed.
FilH said:
GT03ROB said:
FilH said:
Would a shed do?
Helped put a b&q shed up a few year back to hide a mates unsightly heating oil tank. Which looked a lot better, and they went on to add a few potted plants and baskets around the shed.
For LPG that is not allowed.Helped put a b&q shed up a few year back to hide a mates unsightly heating oil tank. Which looked a lot better, and they went on to add a few potted plants and baskets around the shed.
We did the opposite and had an underground tank removed by Flogas. Cost something like £2k all in for their labour; would imagine an installation might cost a similar amount of money. It's a hole with a bed of gravel in the bottom of it and they'll probably charge you for a 'new' tank too.
We had a new tank fitted about 9 years ago when we moved in. Supplier had fixed rates for tanks - supply, site & connect - £250 above, £500 below ground.
I had a big hole dug by man with digger and trench up the driveway for them to lay pipe from tank to stop valve - man and digger £250 for a day. Gas company turned up with tank on a truck and two concrete plinths that are put into the whole first for the tank to sit on and be strapped to. Then their engineer laid pipework from tank to vavle on outside wall of house, connected and tested.
Then £50 for a pump to empty the hole on installation day (we have a high water table) and a lot of spade work to backfill with sand against the tank - about 7 tonnes if i recall.
They were very fussy about make show no damage to paintwork on the tank as even a scratch accelerates rust which is a bit of a risk on a 2000l tank
All in about £1K
I had a big hole dug by man with digger and trench up the driveway for them to lay pipe from tank to stop valve - man and digger £250 for a day. Gas company turned up with tank on a truck and two concrete plinths that are put into the whole first for the tank to sit on and be strapped to. Then their engineer laid pipework from tank to vavle on outside wall of house, connected and tested.
Then £50 for a pump to empty the hole on installation day (we have a high water table) and a lot of spade work to backfill with sand against the tank - about 7 tonnes if i recall.
They were very fussy about make show no damage to paintwork on the tank as even a scratch accelerates rust which is a bit of a risk on a 2000l tank

All in about £1K
cliffords said:
….Beware of the water table before you do it .
This.Daughter is on a small development with communal gas tanks, builder put them in a couple of inches low which was fine until it rained, the water level rose and turned off the gas. They had to come back and redo the tanks so they now have a mound in the communal grassed area.
IJWS15 said:
cliffords said:
….Beware of the water table before you do it .
This.Daughter is on a small development with communal gas tanks, builder put them in a couple of inches low which was fine until it rained, the water level rose and turned off the gas. They had to come back and redo the tanks so they now have a mound in the communal grassed area.
Gassing Station | Homes, Gardens and DIY | Top of Page | What's New | My Stuff