macallister shredder blade replacement

[p1doc]

trying to replace blade on macallister ms2500 blade stuck on like concrete so no give using hex key apart from wd40 any ideas as blade needs replacing

[p1doc]

GliderRider said:

As VTC says, an impact driver, tightening first, or if you haven't got an impact driver, a hex bit of the right size held in a ring spanner, then whilst tightening it as much as you dare, hit the end of the bit with a hammer.

thanks will try this as no impact driver left it soaking in wd40 since yesterday

[p1doc]

motor went whiney then bang typically no longer available so got equivalent macallister 2400 which.... has a single blade rather than 2 small blades so will see how this goes got £10 discount as bandq member and has lasted over a year