Primo Designs Ltd - GTM Coupe is it still manufactured ?
Discussion
gtmdriver said:
fuoriserie said:
Ferg said:
It was built by John Dickens, your fellow CKC contributor. There must be build pics all over the place!
AHA!!
http://s41.photobucket.com/albums/e254/gtmdriver/G...
Thanks for these pictures...AHA!!
http://s41.photobucket.com/albums/e254/gtmdriver/G...
Edited by Ferg on Sunday 1st November 10:25
Italo
It was a nice little car but unfortunately, once I retired from the daily job, it was covering no mileage at all and it was too good a car to sit idle so I sold it to Trap. I believe it has now been sold again?
John Dickens (gtmdriver)
I also like your Marcos job......
I like small fast cars and I believe they're set for a come back in the near future as big manufacturers are investing heavily in citycars.
Welcome in the forum and looking forward to your future contributions in this kitcar forum......
Cheers
Italo
A rebuild project with a bespoke steel chassis.......
http://www.turbominis.co.uk/forums/index.php?p=vt&...
I like it.
http://www.turbominis.co.uk/forums/index.php?p=vt&...
I like it.
Edited by fuoriserie on Wednesday 14th April 13:20
Ken555 said:
Yes !!....that was the GTM ....Thanks....Derek Hambly said:
Hi there,
I have recently purchased the moulds and jigs for the Primo Coupe and intend to put it back into production.
The car is small but is lot easier to get in and out of than an MG Midget and has more room inside.
Always though it was a great car - In fact I had it's successor the Rossa GTM for a couple of years. Will you be able to source the glass at a reasonable price? I have recently purchased the moulds and jigs for the Primo Coupe and intend to put it back into production.
The car is small but is lot easier to get in and out of than an MG Midget and has more room inside.
Derek Hambly said:
Hi there,
I have recently purchased the moulds and jigs for the Primo Coupe and intend to put it back into production.
The car is small but is lot easier to get in and out of than an MG Midget and has more room inside.
Congratulations and looking forward to the new kits....I have recently purchased the moulds and jigs for the Primo Coupe and intend to put it back into production.
The car is small but is lot easier to get in and out of than an MG Midget and has more room inside.
Derek Hambly said:
Hi there,
I have recently purchased the moulds and jigs for the Primo Coupe and intend to put it back into production.
The car is small but is lot easier to get in and out of than an MG Midget and has more room inside.
ive got a gtm coupe and its great once you are in it, but getting in and out isn't the easiest thing as the doors are so short, so the inner door cards always end up with muddy marks on them!I have recently purchased the moulds and jigs for the Primo Coupe and intend to put it back into production.
The car is small but is lot easier to get in and out of than an MG Midget and has more room inside.
its a great car though,
Gassing Station | Kit Cars | Top of Page | What's New | My Stuff