Low rev misfire
Discussion
Jhonno said:
CerbWill said:
The arm connecting the rod linking the 2 banks to the spindle running through the throttle bodies? There's a grub screw holding the arm on and, on the 4.2 arrangement at least, it's on the underside. Maybe check that's not vibrated loose?
I didn't realise that.. Good shout ta. Nice and awkward to get to I am sure!Byker28i said:
Good news.
If you've the original throttle arm, it might be worth replacing with a threaded bar and some ball joint sockets.
Some made them using threaded bar and joint ends.
https://www.ondrives.com/search?cid=0&q=ras5
Or you can go better. You need 1 each of the 5mm ones CFF.00.05 and CFF.00.05LH
https://www.ondrives.com/search?cid=0&q=CFF.00...
Model car's have reverse threaded turnbuckels such as
https://www.boltonmodelmart.co.uk/sw-330123a-swork...
Some made them
https://www.pistonheads.com/gassing/topic.asp?h=0&...
https://www.pistonheads.com/gassing/topic.asp?h=0&...
I have one - it's really good for setting up and maintaining the throttles.
Not a bad shout for a future mod.. My ends are getting a bit sticky to adjust.If you've the original throttle arm, it might be worth replacing with a threaded bar and some ball joint sockets.
Some made them using threaded bar and joint ends.
https://www.ondrives.com/search?cid=0&q=ras5
Or you can go better. You need 1 each of the 5mm ones CFF.00.05 and CFF.00.05LH
https://www.ondrives.com/search?cid=0&q=CFF.00...
Model car's have reverse threaded turnbuckels such as
https://www.boltonmodelmart.co.uk/sw-330123a-swork...
Some made them
https://www.pistonheads.com/gassing/topic.asp?h=0&...
https://www.pistonheads.com/gassing/topic.asp?h=0&...
I have one - it's really good for setting up and maintaining the throttles.
Byker28i said:
If only it had just come in a can!Gassing Station | Cerbera | Top of Page | What's New | My Stuff