Anyone got a Tamora roof panel?
Discussion
You may find that the hinge is fixed with a nut and (not fixed) bolt (in the boot).
M8 'should' be the size of bolt but then again that size may not have been what was lying on the shop floor at the time of the build. Length? Well, it is only a grp bulkhead - 10mm thick. Plus M8 nut and washer - 12mm. Plus carpet - 5mm. Plus hinge bracket and washer - 5mm. Plus two threads out of the nut - 2mm. So 34mm for a bolt.
M8 'should' be the size of bolt but then again that size may not have been what was lying on the shop floor at the time of the build. Length? Well, it is only a grp bulkhead - 10mm thick. Plus M8 nut and washer - 12mm. Plus carpet - 5mm. Plus hinge bracket and washer - 5mm. Plus two threads out of the nut - 2mm. So 34mm for a bolt.
On further investigation the OE pivot is a LT77 gear lever bearing in the hoop and a brass bobbin bonded into the shell. The drivers side was a M10 x 25mm button head ..the passenger side was a cropped down slotted head set of 27mm ...I have decided to replace both bushes, add a washer to stop the nylon bush from being crushed then go to M10 x 30 and Loctite (double check it prior to fitting). A@
Edited by Adrian@ on Monday 28th March 14:27
Gassing Station | Tamora, T350 & Sagaris | Top of Page | What's New | My Stuff