PH BB Mechanics, help me!

[VidalBaboon]

Its sat on my kitchen table That i destroyed with carb cleaner Last week

Will be trying it tomorrow

[Fleegle]

Check that you haven't wired your Starcom into the HT lead

[VidalBaboon]

You're killing me Fleegle

[J B L]

Tic-toc, tic-toc, tic-toc, tic-...

I'd take Pete's offer if I were you.

[jackthelad1984]

Buy a newer honda,problems solved!!

[VidalBaboon]

jackthelad1984 said:

Buy a newer honda,problems solved!!

Wash your mouth out! Even your neighbors don't like Hondas

[RizzoTheRat]

Clutching at straws here but did you connect up the choke cable when you changed the carbs, and if so could there be something funny going on that's causing it to pull the choke out?

[VidalBaboon]

It's possible, I doubt it though because if the cable was tight, it'd get better/worse depending on the angle of the handle bars.

[sprinter1050]

All this talk of fuelling/carb issues but in my utterly incompetent mechanical mind I'd ALWAYS first check electrical issues for an engine that doesn't seem to want to rev or pull under load.

Maybe Fleegle's CDI suggestion is getting close to the problem.

Signed
Mike the Mechanic

[Fish981]

Have you tried brand new petrol?

[3doorPete]

Have you tried turning it off and turning it on again?

[VidalBaboon]

All Hamsters are fed and watered.

[VidalBaboon]

woohoo! it's fixed! It turned out to be the Pulse coil pick up.

[CQ8]

[3doorPete]

VidalBaboon said:

woohoo! it's fixed! It turned out to be the Pulse coil pick up.

Nice one! Are you going to put the old carbs back on and blank off the emmissions crap again?

[VidalBaboon]

Not before I go on me hols on it next weekend! It's just begging for trouble

[bob1179]

Good news mate, need a beer to celebrate!

[sprinter1050]

VidalBaboon said:

woohoo! it's fixed! It turned out to be the Pulse coil pick up.

sprinter1050 said:

All this talk of fuelling/carb issues but in my utterly incompetent mechanical mind I'd ALWAYS first check electrical issues for an engine that doesn't seem to want to rev or pull under load.

Maybe Fleegle's CDI suggestion is getting close to the problem.

Signed
Mike the Mechanic

Just checking how you'd got on VB