Ecu upgrade, what to expect ?
Discussion
phazed said:
Richard 858 said:
All being well you and Anthony will be the first to see the results first hand next Sunday morning! At least I assume that's what you're referring to Peter?
I possibly wrongly assumed that there was a problem with Ian's car?Had the same fault on the Cerb and that cost a lot more...
N7GTX said:
phazed said:
Richard 858 said:
All being well you and Anthony will be the first to see the results first hand next Sunday morning! At least I assume that's what you're referring to Peter?
I possibly wrongly assumed that there was a problem with Ian's car?Had the same fault on the Cerb and that cost a lot more...
Mines just in for a change of Ecu and wiring - had no end of issues with the DTA Ecu and could not get anyone to map it properly so I am having it all ripped out and going for the MBE. Not aware of any other problems - yet! But it does sound a bit tappety.......
Will chase up Dom this week
roseytvr said:
...... But it does sound a bit tappety.......
Yes.....fingers crossed for you that you don't have the 4>1 leak issue, or leaking gaskets.To the either Ian - I have one spare manifold (bought a pair off another PHer, he didn't realise that one had been welded back inaccurately after 4>1 welding and was half an inch too short). Cannot remember which side, think it is still catted and I think it has already been welded at the 4>1 union, but if you need it just holler and I will check those facts.
QBee said:
To the either Ian - I have one spare manifold (bought a pair off another PHer, he didn't realise that one had been welded back inaccurately after 4>1 welding and was half an inch too short). Cannot remember which side, think it is still catted and I think it has already been welded at the 4>1 union, but if you need it just holler and I will check those facts.
Thanks for the offer QBee but Dom has twisted my arm again. He's good at that With the nice shiney Y piece already in place the ACT ones will look a lot better and blingy. Only trouble is it will start to look like Mac's soon....
phazed said:
Ian, are you running a solid camshaft?
Nope, and unfortunately it's looking grim. All rocker pads and valve ends are knackered and it's a strip down job to find the bits and any other damage on a brand new engine that's done less than 5000 miles😡 Will start a new thread when appropriateIan
roseytvr said:
Nope, and unfortunately it's looking grim. All rocker pads and valve ends are knackered and it's a strip down job to find the bits and any other damage on a brand new engine that's done less than 5000 miles?? Will start a new thread when appropriate
Ian
Oh FFS, what a nightmare! I remember speaking to you at Castle Combe and it did sound a bit tappitly then.Ian
Surely the engine builder will see this right?
Dom's just called to say the car is finally mapped at long last. I was that giddy I forgot to write down the figures but from memory I think it was 352bhp and 372ft/lbs at 10lbs boost.
If the injectors were bigger we could go on.....
Can't collect until early next week and need a DRY day to drive home. Will post up the dyno results later.
I'm as excited as Alun on here now.
If the injectors were bigger we could go on.....
Can't collect until early next week and need a DRY day to drive home. Will post up the dyno results later.
I'm as excited as Alun on here now.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff