Drivers Door Mirror Loose
Discussion
As the title says, my drivers door mirror has come loose. I've seen plenty of topics on here about how to get it off, how the grub screw comes loose and how to fix it. But I can't seem to find how to get the actual mirror off the tripod to get better access.
I've the speaker out and cables disconnected. Pictures attached of the stage I'm at. Any help greatly appreciated!
I've the speaker out and cables disconnected. Pictures attached of the stage I'm at. Any help greatly appreciated!
bobfather said:
Spiike said:
Thanks, but I can't get access to the grub screw unfortunately. The tripod is spinning on the inner metal base, so I'm unsure where to go from here or how to get it off, the base piece seems locked solid to the door.
From inside the door speaker opening, separate the two plugs for the mirror, mirror motors and mirror heater are separate plugs. Once this is done you can use the mirror to unscrew the whole unit from the door. The plugs are too big to fit through the hole so you'll either have to cut wires or disassemble the plugs scottliv said:
If the tripod is spinning on the boss screwed into the door use a parallel punch or screwdriver into the slots of the boss. Tap it around to loosen. Put a couple of layers of tape around the hole to protect the paintwork.
You can just see the slots in the picture.
I don't have much access as shown in my photo above but I'll certainly give the tapping method a try, see what I can get access with, cheers! I'll get back with how I get on. You can just see the slots in the picture.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff