New Stuff

[PeteGriff]

Further to other bits I have had made in the past I have made or making the following (all based upon what I have developed for my Griff):

1. Stainless front top wishbone spacers in 2, 3, 5, 8 mm
2. Stainless Front Wishbone Heat Shields, both slotted hole version for easy fitting without removing bolts, and standard holes.
3. Aluminium front air splitters
4. Stainless polished Coil mounting bracket.

Will post some pictures later. I shall be taking some samples along to the Growl if interested.

All the best, Pete

[PeteGriff]

Rob_the_Sparky said:

Wishbone heat shields sound good, been a bit concerned about how close the exhaust runs to them.

Are you at the Growl Rob? The ones I designed for my Griff and will be able to supply are stainless with a layer of the heat reflective matting where the exhaust runs. The slotted hole version will allow fitment by just loostening bolt, therefore nice quick fitting. I now have the flat profile laser cut on a few samples, Just need to get them folded up. Regards, Pete