4 pot disc`s + heater valve

[oldboyracer64]

hi just robbed a metro of it`s brakes and head but how do you fit four pots pipeing to a mini . on the head where the heater valve goes on a mini there is no water hole do i need to get this drilled out or is there another way to do this . one more can i use the long cluch arm if i fit a servo or do i need the short one thank you david

[oldboyracer64]

i have both cluth`s so dont mine which i use but with the long arm will there be room for the servo
with the brakes can i use the metro hub and drive shafts
to drill the head can this be done diy or does it need to be done by a pro thank you

[oldboyracer64]

the mini we have is a 1978 the metro engine is a 1984
i have been told that it is an mg but i dont know for sure . as you may guess i am new to these minis so sill very green but learning fast hense all the cuts on my hands think i may have taken to much on but i keep going.