Steering wheel
Discussion
Sandgrounder said:
badge is 51mm diameter!
This one is flat on the face, 65mm overall x 1mm thick, shoulder 59.8mm x 4 mm deep. I’ll try doing one with a 51mm recess in the face so your badge sits perfectly central, not sure how that will come out, but I’ll give it a go. Can always tweak the dims once you’ve tried them if required. You may want to give them a light sand and spray over.
Private message me the address and I’ll bob them in the post tomorrow.
Sandgrounder said:
Package arrived Lee. I'll take a wander to the garage at the weekend and see if it fits.
Let me know your costs and I'll reimburse you.
Many thanks
No cost, glad to help. Let me know if any tweaks are required. Now the models done it’s a 2 minute job to adjust any dim. Let me know your costs and I'll reimburse you.
Many thanks
Sandgrounder said:
This is the non recessed one. Recess probably needs to be 51mm diameter. Shoulder diameter probably needs to be 61but a layer of insulation tape will absorb the small amount of play.
The recess should be 51mm now, I’ll double check though. Looks like the overall dia is close to the fixings so may reduce by 2mmSandgrounder said:
Don't know, but as soon as I saw the S2 on Wheeler dealers, I knew that was the colour I wanted .
Haha same hear. I am getting my resprayed in the new year and 80% sure now its gonna be blue, there are plenty to choose from though!. Is that the the original colour as will have a paint code in the engine bay?Gassing Station | S Series | Top of Page | What's New | My Stuff