Discussion
Hi all , after stripping my engine 4.0 pre serp rover v8?
It is fitted with a H218 Kent camshaft which seems ok so I will be putting it back however on pulling it out I noticed it was retarded by 2 degrees!
Has anyone got some information so I can set this up and to why the cam was retarded ?
My assumption was so the valves did not hit the Pistons ?
Your opinions will be most welcome :-)
I could do with dialling this in this weekend !
Thanks ste.
It is fitted with a H218 Kent camshaft which seems ok so I will be putting it back however on pulling it out I noticed it was retarded by 2 degrees!
Has anyone got some information so I can set this up and to why the cam was retarded ?
My assumption was so the valves did not hit the Pistons ?
Your opinions will be most welcome :-)
I could do with dialling this in this weekend !
Thanks ste.
phazed said:
Did you make the effort to check the timing properly before you removed the cam?
If so, that was very diligent!
That cam is a Kent cam, contact them for timing details.
Well yes I did sort off as I noticed it was retarded by 2 deg but as I was fully rebuilding the engine I was wanting to set it up properly :-)? But I will contact Kent for setup details ! If so, that was very diligent!
That cam is a Kent cam, contact them for timing details.
Thanks
Ste .
Gassing Station | General TVR Stuff & Gossip | Top of Page | What's New | My Stuff