Need a brake-line connector!

[LeeHodges]

Hi

Whilst rebuilding my car's rear brake pipes, I have had to replace the rear bias valve, the T-junction and pipes. However, Racetech could not provide the 'M10 Male' to 'M12 Male' connector that joins the splitter to the valve. Neither could Powers and TVR Parts didn't even bother to respond to my query. Can anyone suggest where I can get such a connector? I have tried 'third-parties' on the net but no luck there either!

The image below shows the new kit, the old connector (which took most of the old valve's thread with it!) and the M10-to-M10 connector which I bought in error:



TIA!

Lee

[GAjon]

Take a look on Demon Tweeks site or QUestmead.

[phillpot]

Would this do the job?

Might need a copper washer to seal into bias valve then use your M10 double male to join to the tee?

[LeeHodges]

Thanks folks. I think you're right, Phillpot; Automec did suggest the same route, which I think I'll have to go with, despite that it introduces another potential leak point

https://www.automec.co.uk/collections/brass-fittin...
https://www.automec.co.uk/collections/brass-fittin...