AP Brakes

[FrenchTVR]

Hi all, further to my earlier post about my new big brakes on the Wedge forum, can anyone tell me what sort of fittings normally go into AP calipers. After this afternoons fiasco where I realised that standard flared fittings/pipe aren't suitable I think I need a 90degree hydraulic face fitting, which then goes direct to the stainless flexi. Can anyone deny/confirm this please? Any photos would be useful.

Many thanks,

Mick

[johno]

AP's use a Banjo fitting on the back of the inner face of the caliper .... I know as my 4 pot's have just arrive

I already have braided lines so I got replacement ends from Braided steel/Aerotek .... they have a site. The product code is ..

5094-3P (these are 40 degree banjos, you can get them straight)
775-3P These are the required bolts.

Don't forget the crush washers ... Their site details all the available sizes...