Pistonheads bike stickers
Discussion
Had a go at a PedalHeads/PistonLegs logo myself taking inspiration from rhinochopig.
Took on board the suggestion that the pedals were not quite right. It is difficult as to get proportions correct the pedals need to overlap the 'gear smilie'. Any suggestions?
Took on board the suggestion that the pedals were not quite right. It is difficult as to get proportions correct the pedals need to overlap the 'gear smilie'. Any suggestions?
Edited by RosscoPCole on Sunday 1st August 20:27
I think they both need the pedals to look more like pedals - I knocked mine up in about 10 minutes and didn't have timne to make the pedals more realistic. Ideally you want a V12 type pedal (as suggested) or an SPD outline.
Both are a bit too simple and do not look sufficiently pedal like.
Both are a bit too simple and do not look sufficiently pedal like.
Here is a version of the logo with a V12 pedal. Having the pedals at an angle just looked wrong. Also an SPD pedal looked like a strange lump! Using the V12 pedal gives the most pedal-like design. What do you think?
Shame I'm not at work as I could have make a few on the vinyl cutter.
Shame I'm not at work as I could have make a few on the vinyl cutter.
Edited by RosscoPCole on Monday 2nd August 08:42
Edited by RosscoPCole on Monday 2nd August 08:43
Hi Guys, some interesting ideas being posted here. At the moment I must be frank with you and say that it's not high up the list of things for us to produce. However, I suspect that if (if) it did happen then it would need to work in a pre-order format, similar to what Stuart did with the shirts.
Never say never, but I'm afraid that bike stickers are not going to be offered just yet
Never say never, but I'm afraid that bike stickers are not going to be offered just yet
Gassing Station | Pedal Powered | Top of Page | What's New | My Stuff