Low Rise Inlet Manifold?
Discussion
ss64ii said:
For a really low inlet, some of the boat manifolds had the carb almost as low as the rocker cover rails,performs fairly well as they were on 260hp 350s.
i have seen those used even with huge blowers strapped on top! i also thought elbroke or someone did low rise manifolds! Chris.
ss64ii said:
Sorry.It was the XC-8.
The X-C8 isn't going to make it low-rise at all. http://cgi.ebay.com/ebaymotors/EDELBROCK-X-C8-CROS...
Hillborne injection with the right trumpets might do the trick.
http://www.hilborninjection.com/product.asp?Id=56&...
For my own engine, I've looked at building my own inlets. I looked at that weber cross-over manifold, but it's for a 23deg head engine, where mine uses NASCAR/Busch heads (18deg) and the intake ports are different.
I'll either go for Hillborne, or similar when I finally go injection and release another 70-100bhp!!!
thunderbelmont said:
ss64ii said:
Sorry.It was the XC-8.
The X-C8 isn't going to make it low-rise at all. http://cgi.ebay.com/ebaymotors/EDELBROCK-X-C8-CROS...
Hillborne injection with the right trumpets might do the trick.
http://www.hilborninjection.com/product.asp?Id=56&...
For my own engine, I've looked at building my own inlets. I looked at that weber cross-over manifold, but it's for a 23deg head engine, where mine uses NASCAR/Busch heads (18deg) and the intake ports are different.
I'll either go for Hillborne, or similar when I finally go injection and release another 70-100bhp!!!
Gassing Station | Yank Motors | Top of Page | What's New | My Stuff