Plug Stuck In The Bath

Author
Discussion

Adz The Rat

Original Poster:

14,139 posts

210 months

Wednesday 16th March 2011
quotequote all
The plug in our bath is a metal one which has got itself stuck in the hole!
It seems to have been pushed down a little too far and I cant get it out at all, no room to get down the edge with a screwdriver.

Any ideas how to get it out before I drill a hole in it?

TankRizzo

7,278 posts

194 months

Wednesday 16th March 2011
quotequote all
What about putting a plunger over it with a bit of water and pulling up sharply?

davepoth

29,395 posts

200 months

Wednesday 16th March 2011
quotequote all
water in or out?

If the water is out it might be easier to go from underneath, take the pipe off and push the plug up.

mybrainhurts

90,809 posts

256 months

Wednesday 16th March 2011
quotequote all
rofl...best thread ever

Send it a strongly worded email....

Adz The Rat

Original Poster:

14,139 posts

210 months

Wednesday 16th March 2011
quotequote all
PH is the first place I look for answers to such problems! laugh


Water is out and we dont own a plunger.

mybrainhurts

90,809 posts

256 months

Wednesday 16th March 2011
quotequote all
Buy a plunger...

shirt

22,619 posts

202 months

Wednesday 16th March 2011
quotequote all
speaking from experience, a stanley blade will fit. aim to bring it up only slightly (else it'll snap) so you can get your nail under or the screwdriver. adjust the screw (i'm assuming its a pop up waste) and check it now & again.


next time you're in ikea, buy a gu10 bulb. they come with a small suction cup that is perfect for doing this.

Wacky Racer

38,186 posts

248 months

Wednesday 16th March 2011
quotequote all
mybrainhurts said:
Buy a plunger...
hehe

Morningside

24,111 posts

230 months

Wednesday 16th March 2011
quotequote all
13 amp? (Sorry, had to be done).


Metal? How about freezing it or heating the surrounding hole.

Expansion and all that.

mybrainhurts

90,809 posts

256 months

Wednesday 16th March 2011
quotequote all
Right, this is what you do...

Bit of water in bath, not much...

Lower your bare arse over the plug...

Clench and unclench your bum to create suction...

Repeat until plug surrenders...

Job's a good 'un, but make sure you don't swallow the plug...smile

GTDNB

660 posts

171 months

Wednesday 16th March 2011
quotequote all
chuck a load of ice in the bath it might make the metlal contract enough to loosen the plug a bit. perhaps persuade it with a gentle bit of tap on the side of the bit the chain attaches to. freeze spray or butane might do the trick if you have either of those.

Wacky Racer

38,186 posts

248 months

Wednesday 16th March 2011
quotequote all
Drill a small hole in the plug and lever it out with a small rod like a knitting needle........teacher

Adz The Rat

Original Poster:

14,139 posts

210 months

Wednesday 16th March 2011
quotequote all
shirt said:
speaking from experience, a stanley blade will fit. aim to bring it up only slightly (else it'll snap) so you can get your nail under or the screwdriver. adjust the screw (i'm assuming its a pop up waste) and check it now & again.


next time you're in ikea, buy a gu10 bulb. they come with a small suction cup that is perfect for doing this.
Will try this approach, thanks!

davepoth

29,395 posts

200 months

Wednesday 16th March 2011
quotequote all
Half a tennis ball might do the job, a plunger would be better though.

fido

16,807 posts

256 months

Wednesday 16th March 2011
quotequote all
http://www.maplin.co.uk/freezer-spray-26296 .. not tried it myself .. but if you restricted the cooling to the plug!

Adz The Rat

Original Poster:

14,139 posts

210 months

Wednesday 16th March 2011
quotequote all
Stanley blade did it, cant believe I didnt think of that earlier.

Can get back to making the whiskey now.

mybrainhurts

90,809 posts

256 months

Wednesday 16th March 2011
quotequote all
Deep joy...smile

mat13

1,977 posts

182 months

Wednesday 16th March 2011
quotequote all
Has anyone checked the health forum for the "ive removed the end of my thumb with a stanley blade and dropped it down the plug hole" thread?

mybrainhurts

90,809 posts

256 months

Wednesday 16th March 2011
quotequote all
hehe

Call an ambiwlans....

Ricky_M

6,618 posts

220 months

Wednesday 16th March 2011
quotequote all
If the bath is empty, remove bath trap and poke it from underneath with something?

ETA: Never mind, see you've already sorted it!