Pictures of decently Modified cars [Vol. 2]

[Meridius]

Its a 9/10, loses a point because I like when those 'twist' wheels point forwards instead

The green, tan leather and a bit of chrome combo is so good on cars of that pre-90s era though.

[Matt Cup]

Meridius said:

Its a 9/10, loses a point because I like when those 'twist' wheels point forwards instead

The green, tan leather and a bit of chrome combo is so good on cars of that pre-90s era though.

At least the wheels aren’t asymmetrical so all you need to do is swap sides and you can have them pointing in the other direction

[boyse7en]

Is there some sort of significance to the socket wrench left in the back?

[swampy442]

RB Will said:

Should be a bit lively

Good old 2JZ, be interested to find out what manifold/turbo that is

[Fastdruid]

boyse7en said:

Is there some sort of significance to the socket wrench left in the back?

Left in there after swapping the wheels round to annoy people on the internet.

[sc0tt]

RB Will said:

Stunning

[Baron Greenback]

Alternative version!


Back in the 1950s, Chevrolet built a few wagon concepts around a Corvette chassis and powertrain. Those concepts were all destroyed, but this recreation shows what might have been.

[Miserablegit]

Matt Cup said:

At least the wheels aren’t asymmetrical so all you need to do is swap sides and you can have them pointing in the other direction

I’d never be seen in that...because I’d never be able to make my mind up about which way the wheels should point!! Perhaps buy a spare set and install them in different directions on each side...
Lovely looking

[MDMA .]

Fastdruid said:

boyse7en said:

Is there some sort of significance to the socket wrench left in the back?

Left in there after swapping the wheels round to annoy people on the internet.

Or likes removing the rear wiper for pictures

[Caddyshack]

boyse7en said:

Is there some sort of significance to the socket wrench left in the back?

Probably adjusting the handbrake looking at the angle it is up at.

[thebigmacmoomin]

Baron Greenback said:

Alternative version!


Back in the 1950s, Chevrolet built a few wagon concepts around a Corvette chassis and powertrain. Those concepts were all destroyed, but this recreation shows what might have been.

I prefer what Chevrolet eventually made, the '55 to '57 Nomad.

[irocfan]

Baron Greenback said:

Alternative version!


Back in the 1950s, Chevrolet built a few wagon concepts around a Corvette chassis and powertrain. Those concepts were all destroyed, but this recreation shows what might have been.

[RB Will]

swampy442 said:

RB Will said:

Should be a bit lively

Good old 2JZ, be interested to find out what manifold/turbo that is

No idea on the manifold and turbo but apparently its a 1jz not 2

[Jader1973]

I saw this at a show at the weekend. A 1966 Mercedes 250 SE with a 4.0 turbo charged straight six Ford Barra engine. I’m going to guess (given the red cover) that this is a 245T which if it is stock would put out 329 hp and 480 Nm. That is slightly more than the 110 hp and 216 Nm the car left the factory with!

[Matt Harper]

This is actually a late model Challenger Hellcat, modified to look like a 69 Charger. The wheels don't do it any favors, but otherwise it looks pretty badass.

[irocfan]

TBH I'd be quite chuffed with this....

[Joelonghair]

That looks ridiculous! Like a tug boat of the automotive world.

I'm sure it's a blast just not for me.

[ZX10R NIN]

irocfan said:

TBH I'd be quite chuffed with this....

Damn

[Fermit and Sexy Sarah]

irocfan said:

TBH I'd be quite chuffed with this....

That's more American than George Washington's horse

[RB Will]

The front grille is putting me off.