Engine swap - Drive shafts?
Discussion
I'm not actually doing an engine swap but it's probably the easies way for me to get the answer I need for what I am planning to do.
When you do an engine swap in a car and change the gear box too (say, putting an engine from a different manufacturer etc) how do most people go about dealing with the drive shafts?
Is it possible to cut and weld 2 different shafts together so that the joints on each end are different or do most people get whole new shafts made up from scratch?
When you do an engine swap in a car and change the gear box too (say, putting an engine from a different manufacturer etc) how do most people go about dealing with the drive shafts?
Is it possible to cut and weld 2 different shafts together so that the joints on each end are different or do most people get whole new shafts made up from scratch?
Gassing Station | General Gassing | Top of Page | What's New | My Stuff