Does 3000m need original bolt on fan with kenlow
Discussion
I have recently purchased a tvr3000m which has a kenlow fan, but the original bolt on fan has been removed.
Due to the potential overheating issues / runnning hot etc, should I source a bolt on fan or is it ok to run with just the kenlow.
If I need to source a bolt on fan does anybody know where I can get one.
Many Thanks
Paul
Due to the potential overheating issues / runnning hot etc, should I source a bolt on fan or is it ok to run with just the kenlow.
If I need to source a bolt on fan does anybody know where I can get one.
Many Thanks
Paul
I'd have said not - I was advised when fitting Kenlowes not to put the original back on to the front pulley's, as it will disrupt air flow created by the Kenlowes, hence it could be worse for you rather than better. As I mention, this is all from advice i've received, and hasn't been tested, but its the way i'm going.
Hope this helps,
Tony
Hope this helps,
Tony
Gassing Station | TVR Classics | Top of Page | What's New | My Stuff