Audi 4.2 V8 in a 924.

[Golten951]

SturdyHSV said:

Our two builds (mine far simpler!) have had some similarities, I've just finished doing a load of wiring (albeit just re-routing / extended the factory harness) and have just plumbed in my 10AN oil cooler lines

Are you going to put a thermostat in line with the cooler so it doesn't delay the oil getting up to temperature? I used the Mishimoto one, it's a nicely made piece and the thermostat can be swapped out, it comes with an 85* one.

Great project anyway, all the best with home / work and project progress

Very good, glad you have made some progress as well!

I do plan on doing a inline thermostat. Looking at a couple different temp types. We get some warm temps here where we live. Over 110 degrees F. I was going to use one from Mocal since I get discounts from them.

Thank you on all three my friend! Looking forward to having a our own home soon.

My next goal of progress is getting a seconded bellhousing set up with the T/O bearing/slave cylinder.
Using a low profile Howe racing type.

[Golten951]

Made a little progress. Fabricated my Throttle body Spacer, and Vally pan to run AN lines amd fittings for my AOS system. Parts are not perfect. But when you only have cutting wheels and a drill press, ya do what you can.

[Golten951]