Interest in 4.5 throttle linkage bar
Discussion
Having recently adjusted the throttle, throttle pots, and balanced the flow etc i found the throttle linage bar to be rubbish.
So because of this i am going to be making some new ones, using stainless steel.
They will consist of a proper left hand thread and right hand thread. and hex bar in the centre to help with adjustment if a spanner is needed. will be able to be used with the existing ball joints or rose joints that i have recently upgraded to.
Will be using 5mm threaded bar so the same as the original but offer better adjustment and more secure from coming undone like mine did as i had to remove one of the lock nuts to get the adjustment needed.
i have enough material for about three, one being for myself so have two to offer here.
£25 posted. first come first served.
Peter
So because of this i am going to be making some new ones, using stainless steel.
They will consist of a proper left hand thread and right hand thread. and hex bar in the centre to help with adjustment if a spanner is needed. will be able to be used with the existing ball joints or rose joints that i have recently upgraded to.
Will be using 5mm threaded bar so the same as the original but offer better adjustment and more secure from coming undone like mine did as i had to remove one of the lock nuts to get the adjustment needed.
i have enough material for about three, one being for myself so have two to offer here.
£25 posted. first come first served.
Peter
Gassing Station | Cerbera | Top of Page | What's New | My Stuff