slave and release bearing differences on a cerby
Discussion
Steve
Your right I suspect that I have incopatable bits. i also suspect that its either the release bearing or the slave that is the culprit. But I can't be for sure. Hence the question!
From my measurements the release bearing is putting pressure on the fingers even when pushed fully back. So I have an interference fit if you like!
Your right I suspect that I have incopatable bits. i also suspect that its either the release bearing or the slave that is the culprit. But I can't be for sure. Hence the question!
From my measurements the release bearing is putting pressure on the fingers even when pushed fully back. So I have an interference fit if you like!
Gassing Station | Cerbera | Top of Page | What's New | My Stuff