Renewing prop shaft bearing on a monaro

[Powermaster1]

Just wondering I’m going to attempt to change the prop shaft bearing on my monaro at home is there anything I should know as never done this before on any car

[maccavvy]

you need it jack it up high enough to have both wheels off the floor
Seperating both halves of the shaft may need a large hammer ,reinstall with plenty of coppa slip
you may need to remove the center section of exhaust to get the prop off
youll need a suitable diameter drift to knock it on the shaft. its a simple install with the correct tools

i marked everything up so it went back exactly how it came off.

[Powermaster1]

Many thanks for the info

[bonesxu1]

Powermaster1 said:

Just wondering I’m going to attempt to change the prop shaft bearing on my monaro at home is there anything I should know as never done this before on any car

This is a good vid, there are probably more on Youtube.
https://www.youtube.com/watch?v=HTRkpTCbbc4

[ShavedBadger]

It's worth inspecting and probably replacing the rubber couplers at each end of the propshaft while you're at it.