CJ Autos Hydraulic Ramps and Sagaris

[tvrsi1]

Anyone managed to get a Sagaris on the CJ Autos Hydraulic ramps, just wondered if the approach angle and also the wheel stops do not foul the splitter. Any advice on how others lift their Sagaris would be helpful.

[Englishman]

I have some of these ramps but need a couple of 6' scaffold planks to provide a gentle ramp-up to avoid damaging the front splitters!

[tvrsi1]

Hi Thanks for the reply, what about the wheel stops they look a little high are these adjustable. Also do you have two or 4 of these for a complete lift. Looks like a good solution and safer than axle stands.

[Englishman]

I only have one pair but no problem with the wheel stops when using the ramps on either end of the Sag. When using at the rear, you need to watch the front of the car as, if fully extended, the car would touch the ground. I put a piece of carpet under the front just in case I raise it slightly too far!

[tvrsi1]

Thanks for your help Englishman, looks like I need to purchase a pair of them then!