Anyone got a spare plenum ?
Discussion
Another day, another problem
This time it's a problem idle. I always suspected it wasn't right but it didn't feel too bad. Thought I'd check the stepper motor after reading EGB's kangaroo hops post.
I found this,
Taped and glued in place. Before I knew better I thought it was some heat shielding but when I went to it tonight it pretty much came off in my hand.
I see it's just a plate at the back of the plenum so that's what I'm looking for if anyone has any leads. I'll take the full plenum if that's what I can get.
Thanks again.
Colin
This time it's a problem idle. I always suspected it wasn't right but it didn't feel too bad. Thought I'd check the stepper motor after reading EGB's kangaroo hops post.
I found this,
Taped and glued in place. Before I knew better I thought it was some heat shielding but when I went to it tonight it pretty much came off in my hand.
I see it's just a plate at the back of the plenum so that's what I'm looking for if anyone has any leads. I'll take the full plenum if that's what I can get.
Thanks again.
Colin
That's the stepper motor that's broken you wazzock
You'll find the threaded end of it and probably the plunger still in the housing. You'll need to pop the housing off the back of the plenum and dig that mess out on the bench. Shouldn't be too difficult as the steppers are hard plastic bodies, which is why they break when ham fisted clots lean on them
You'll find the threaded end of it and probably the plunger still in the housing. You'll need to pop the housing off the back of the plenum and dig that mess out on the bench. Shouldn't be too difficult as the steppers are hard plastic bodies, which is why they break when ham fisted clots lean on them
Gassing Station | Chimaera | Top of Page | What's New | My Stuff