Injector installation

[Paulprior]

Just refitting my injectors and a bit surprised to see that there is flexibility in the positioning up and down as per the photo below, I guess the one on the left is correct being fully down but would like confirmation?

[rdl001]

You still need to fit the rectangular circlip which holds the injector in the groove against the fuel rail and sets the correct position.

[V8fan]

The one on the left (or the lower one as the photo has appeared ) is correct and the rectangular clip mentioned above will set the height. The other one is not located all the way in.

On my last Chimaera, I found it best to fit the injectors to the rail first, but it's still a bit of a faff. I had a leak at first due to trapping one of the rubber seals (which had been replaced with new ones).

Edited by V8fan on Monday 24th February 10:03

[Paulprior]

thanks guys
Looking through my photos i can see that now, i didnt really look carefully when i removed them, i just assumed that on installation everything would locate correctly when bolted down, but obviously not, my old ones are rusty and horrible so i will buy a new set first, very surprised at the cost though, around £5 each

[Zener]

What V8 fan said ^ and always use engine oil/transmission fluid Vaseline or Silicone grease to lube those upper and lower O'rings or they tear/scar , never torn any in over 33 years on the tools (bloody hell I'm getting on) using above method

[Paulprior]

At 33 years on the tools you could still be a youngster, but yes I greased them, new shiny set fitted, thanks guys