Discussion
Hello Folks,
Bought my chimaera 500 on Saturday after Rob Ingleby inspected it. One of the points he made was that some of the anti corrosion coating on the chassis was flaking off therefore could present risks of rust. Anyone can advise and recommend where i could get it waxoyled? I live in Shrewsbury, shrops.
Cheers guys.
Bought my chimaera 500 on Saturday after Rob Ingleby inspected it. One of the points he made was that some of the anti corrosion coating on the chassis was flaking off therefore could present risks of rust. Anyone can advise and recommend where i could get it waxoyled? I live in Shrewsbury, shrops.
Cheers guys.
This has been discussed many times. I would recommend you get it up on a 4-poster and clean off all visible flaky stuff then go over with a wire brush or similar. Then give it a liberal coat of Hammerite followed by a spray of warm Waxoyl - preferably from an air gun. This will get the job done properly although some on here will show an alternative preference to Hammerite.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff