2.8VR6, which oil?
Discussion
not really done any research, but someone told me semi-synthetic but not sure of grade?
is it not possible to use fully synthetic?
also, after a good run my engine starts to sound a bit unhappy, as if the oil its running is degrading when hot? when fully cooled down (ie oil thickened up) it sounds fine again smooth & no noise
could this be because it may have the incorrect oil in??
any help appreciated
Richard
is it not possible to use fully synthetic?
also, after a good run my engine starts to sound a bit unhappy, as if the oil its running is degrading when hot? when fully cooled down (ie oil thickened up) it sounds fine again smooth & no noise
could this be because it may have the incorrect oil in??
any help appreciated
Richard
Fuchs XTR in mine; again no oil burn, although I'm at 91.5k. Same deal as the Synta from what I can make out. Can't remember the exact grade, will check the bottle later.
I am a touch sceptical when it comes to oils. The handbook tells you the grades and ratings you need to put in. As long as it matches these and you change it regularly then that's all that counts? It has to be better than buying £60+ Carlos Fandango oil then leaving it in for ages...
I am a touch sceptical when it comes to oils. The handbook tells you the grades and ratings you need to put in. As long as it matches these and you change it regularly then that's all that counts? It has to be better than buying £60+ Carlos Fandango oil then leaving it in for ages...
try the guys from www.opieoils.co.uk good priced oil think they are a sponsor on here somewhere
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff